Club RSX Message Board - View Single Post - Intake for nitrous.
View Single Post
Old 01-01-2018, 08:35 PM   #1
Cbt_123
Cbt_123
 
Join Date: Jan 2018
Location: Morgan's point
Posts: 2
iTrader: (0)
Cbt_123 is a jewel in the rough of c-rsx Cbt_123 is a jewel in the rough of c-rsx Cbt_123 is a jewel in the rough of c-rsx Cbt_123 is a jewel in the rough of c-rsx Cbt_123 is a jewel in the rough of c-rsx Cbt_123 is a jewel in the rough of c-rsx Cbt_123 is a jewel in the rough of c-rsx Cbt_123 is a jewel in the rough of c-rsx
Intake for nitrous.

Alright, I've searched about as much as I can and haven't found an answer. From what I understand longer intake runners are better for torque, and short runners are better for hp.
I want that initial torque off the line and hp at the end. So what I'm planning on doing is put a base intake on my type s and run a single port fogger.
My questions are can it be done? Has it been done? What are the results?
Thanks.
Cbt_123 is offline   Reply With Quote