Club RSX Message Board - View Single Post - Intake for nitrous.
View Single Post
Old 01-20-2018, 11:11 PM   #2
m_kluch
kozak
 
m_kluch's Avatar
 
Join Date: Jun 2008
Location: MI
Posts: 634
iTrader: (9)
m_kluch is an unknown quantity on c-rsx
If the tube diameter where it connects to the TB is the same than it can be done. Should it be done? No! Don't waste your time worrying about intake design. The differences in length make a very small difference on the power delivery. Just get a CAI and don't think twice about it.
"longer intake runners are better for torque, and short runners are better for hp" is misleading. What you meant to say was that longer intake runners will produce more torque and hp at a lower rpm while shorter intake runners will produce more torque and hp at a higher rpm.
__________________
Quote:
Originally Posted by luvmyrsx View Post
I had the work done before I found ClubRSX. I am more smarter now.

luvmyrsx
m_kluch is offline   Reply With Quote