This is for the 02-04 RSXs that drive around with a pool of water in their trunk.
Here’s the pool
We need to find out where the leak is.
Remove your carpet, foam board, spare tire, taillight access lid, (and plastic cover if you wish).
To take off the taillight access lids, just pull… very hard
I took off the plastic cover. You don’t have to but it’s quick and it makes the job a little bit easier.
There are only 4 snaps. Just pull and they’re out.
After removing the carpet, foam board, spare tire, and taillight access lid; run water down from the top of the hatch and let it flow through the taillight. Do this until you notice where the water is leaking through.
Here’s the problem
For most people, the problem is usually that their taillight gaskets are bad.
I ordered my new taillight gaskets from acuraoemparts
Part Number: 33502-S6M-A11
Their minimum quantity is 2 so you would pay $16.16 + shipping
These are the gaskets
First thing you need to do is remove your rear bumper
s2k_3.11 has a great DIY for removing your rear bumper here http://forums.clubrsx.com/showthread.php?t=542715
Now that the rear bumper is off, you can move inside the car
Turn the bulb sockets 45° counterclockwise to remove the bulb sockets. Pull the small plug at the end out.
Remove the mounting nuts. There are four 8mm nuts on the inside, 2 screws on the outside (you already took one out when you took off the rear bumper).
I also removed one of the mounting bracket nuts (10mm) to gain full access to the taillight.
Here’s the pool
We need to find out where the leak is.
Remove your carpet, foam board, spare tire, taillight access lid, (and plastic cover if you wish).
To take off the taillight access lids, just pull… very hard
I took off the plastic cover. You don’t have to but it’s quick and it makes the job a little bit easier.
There are only 4 snaps. Just pull and they’re out.
After removing the carpet, foam board, spare tire, and taillight access lid; run water down from the top of the hatch and let it flow through the taillight. Do this until you notice where the water is leaking through.
Here’s the problem
For most people, the problem is usually that their taillight gaskets are bad.
I ordered my new taillight gaskets from acuraoemparts
Part Number: 33502-S6M-A11
Their minimum quantity is 2 so you would pay $16.16 + shipping
These are the gaskets
First thing you need to do is remove your rear bumper
s2k_3.11 has a great DIY for removing your rear bumper here http://forums.clubrsx.com/showthread.php?t=542715
Now that the rear bumper is off, you can move inside the car
Turn the bulb sockets 45° counterclockwise to remove the bulb sockets. Pull the small plug at the end out.
Remove the mounting nuts. There are four 8mm nuts on the inside, 2 screws on the outside (you already took one out when you took off the rear bumper).
I also removed one of the mounting bracket nuts (10mm) to gain full access to the taillight.